1.A connecting website link of an O-ring Chain for common application is pre-coated with grease on the pins. Ahead of connection, verify the grease to the surfaces of pins, and if the quantity of grease is tiny, apply grease with bare hands. (If gloves are used, the grease will probably be absorbed by the gloves.)
Instance: Once the connecting website link (I) of an O-ring chain for basic application is
shipped, O-rings are fitted with the roots from the pins. If the O-rings come loose as a consequence of vibration in the course of transport, refit the O-rings in for the roots of your pins.
In this case, be sure you return the grease collected with the roots with the pins for the central surfaces with the pins, much more at portion A than at portions B shown from the over illustration. (Portions A is worn because of sliding with all the bushings.)
2.The chain might be most easily connected over the teeth of a sprocket. Engage the backlinks at each ends of your chain with all the sprocket teeth and fit connecting pins. If your sprocket is usually moved, the chain can also be linked around the loosened side.
3. Connecting method
one.Verify that O-rings are attached for the roots in the pins.
2.If the level of grease utilized around the connecting pins is tiny, coat the pins with grease at the central portions.
three.Insert the connecting pins to the bushings with the inner backlinks at the two ends.
4.Verify the grease is applied for the complete encounter with the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and even though pressing the connecting plate, install the spring clip. Confirm no matter if the head (the finish with no split) with the spring clip is turned while in the feeding course of the chain. (See the next illustration.)
six.Be sure you verify that the spring clip is securely fitted within the clip grooves in the connecting pins.
This completes jointing of your connecting hyperlink. Note that grease over the surfaces of connecting pins and O-rings could be eliminated all through set up get the job done. In this instance, re-grease applying the grease over the surface from the base chain or the grease within the polyethylene bag by which the connecting link was contained.