SMR Gearbox Set up
Satisfactory overall performance relies on good installation. lubrication and upkeep. hence it is important the directions in the set up and upkeep leaflet. supplied with every single gearbox. are followed carefully. several of the vital elements of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as close towards the reducer doable, and mount reducer on driven shaft as close to bearing as sensible. failure to accomplish this may lead to extra loads within the input shaft bearings and output bearings and could lead to their premature failure.
2. Install 
motor and wedge belt drive with all the belt pull at somewhere around 90° to your center line among driven and input shafts. this can permit tensioning on the wedge belt drive with all the torque arm which really should ideally be in tension. if output hub runs anti-clockwise. torque arm needs to be positioned the correct.
3. lnstall torque-arm fulcrum on a rigid help so that the torque-arm will be at about ideal angles to your center line through the driven shaft as well as the torque arm case bolt. make certain there exists sufficient get up while in the turnbuckle for belt tension adjustment.
Maintain near.
Bell drive might be situated in any practical postion. in the event the torque arm is to be employed to tighten the belts, the drive need to be at about tight angle to your line among the input and output shafts.
Bell drive could possibly be found towards the suitable if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that proven within the illustration.
Torque arm and belt consider up.
Torque arm might be mounted on the correct if wanted.
