Material Handling Electrical power UNIT 1
General Description
This electrical power unit is designed for your fork lift industry, consisting of highly productive gear pump, DC motor, guide raise and reduce valve, tank, ect. The up and down motion are managed from the lever of your guide release valve, that’s equipped with an electric switch to activate the motor. The lowing velocity is managed by the pressure compensated movement control valve.
Particular Notes
one. The duty of this energy unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean all the hydraulic elements concerned just before set up of the electrical power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst, which really should also be clean and free of impurities, N46 hydraulic oil is advised .
four. Oil shifting is required after the preliminary 100 operation hours, afterwards as soon as every 3000 hrs.
5. The energy unit proven is built to be mounted horizontally.
Materials Managing Power UNIT 2
General Description
This electrical power unit characteristics energy up gravity down circuit. Activate the start off solenoid to start out the motor to lift the machine. The lowing movement is activated from the solenoid valve with all the lowering pace managed through the stress compensated movement handle valve. Products of this series might be widely used in the marketplace of logistic units which include fork lift, mini lift table, and so forth.
Specific Notes
one. The duty of this power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean each of the hydraulic components concerned in advance of mounting the power unit.
3. Viscosity of your hydraulic oil shoud be 15~46 cst,which ought to also be clean and no cost of impurities, N46 hydraulic oil is advised .
four. Oil transforming is needed immediately after the first a hundred operation hrs,afterwards as soon as just about every 3000 hours.
5. The power unit needs to be mounted horizontally.