Power UNITS FOR LIFT TABLE 1
General Description
This power unit is intended solely for your tiny lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become widely used within the business of logistic units which include minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled by the solenoid valve together with the speed managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Standard Description
This energy unit is intended solely to the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and the pace controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, however the power supply is reduce, the decreasing motion is managed by the guide override perform.
Electrical power UNITS FOR LIFT TABLE 3
Basic Description
This electrical power unit is made exclusively for that big lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement 
is actived through the solenoid valve as well as the pace controlled by a stress compensated movement handle valve.
Power UNITS FOR LIFT TABLE four
Common Description
This electrical power unit is developed exclusively for the big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the velocity managed by the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is reduce, the lowering motion is controlled by the manual override function.
Specific Notes
one. This electrical power unit is of S3 duty cycle, which may only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean all the hydraulic components concerned in advance of installation of the electrical power unit.
three. Viscosity from the oil shoud be 15~46 cst,which should really also be clean and no cost of impurities.N46 hydraulic oil is advised.
four. Oil transforming is required following the original 100 operation hrs,afterwards after every 3000 hours.
five. The power unit shown is designed to be mounted vertically.
