DUMP TRAILER Energy UNIT- SINGLE ACTING
This electrical power unit has a electrical power up gravity down circuit. Start out the motor to extend the cylinder and activate the solenoid valve to retract the circuit. Manual override to solenoid valve can be offered if essential. Also a stress compen sated movement handle could be added for the circuit to control the descent pace from the cylinder.
Remark: Please seek advice from our product sales engineer to the diverse pump displacement, motor power or tank capability.
one. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean every one of the hydraulic elements concerned in advance of installation of the electrical power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst,which ought to also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
4. The electrical power unit ought to be mounted horizontally.
five. Check the oil level inside the tank just after the first working on the electrical power unit.
six. Oil altering is needed following the preliminary 100 operation hours, afterwards when every single 3000 hours.
DUMP TRAILER Energy UNIT-DOUBLE ACTING
This power unit has a energy up power down circuit with load holding on each A & B ports. A stress compensatred movement handle might be extra to circuit to control the decent pace on the cylinder.
one. This power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
two. Clean every one of the hydraulic elements concerned just before set up of the power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst, which ought to also be clean and free of charge of impurities. N46 hydraulic oil is suggested.
4. The power unit ought to be mounted horizontally.
5. Check the oil degree within the tank following the first running in the power unit.
six. Oil altering is needed immediately after the preliminary 100 operation hrs, afterwards when each 3000 hrs.